Installation

The control card must be integrated into the PCB board slot of the robot system, ensuring precise interface alignment with the device's motherboard to avoid poor pin contact. The installation environment must be far from strong electromagnetic interference sources to ensure signal stability.

Parameter Configuration

Connect the control card to the host computer using the accompanying programming software. Set the signal filtering parameters of the resistor network according to the robot system requirements to ensure signal conversion accuracy. If multi-device linkage is required, the corresponding communication protocol must be matched in the software to complete the analog-to-digital signal conversion rules.

Operation and Debugging

Before powering on, verify the wiring and voltage parameters. After confirming they are correct, start the system and test the control card's signal receiving and sending functions. Observe whether the robot's movements match the commands. If signal delay or deviation occurs, adjust the resistor network filtering parameters through the software or recalibrate the interface connection.

Maintenance Precautions

During operation, regularly check whether the interface pins are loose to avoid vibration causing poor contact. When cleaning, use a dry, soft cloth to wipe; do not use corrosive cleaning agents. If a fault alarm occurs, disconnect the power supply first and have a professional troubleshoot the resistor network or interface fault. Do not attempt to disassemble or modify the device yourself.