DS200PTBAG1B components include 2×72 point terminal block, 3×10 pin connector (JJR/JJT/JJS), 6 independent signal posts.

When the factory needs to use this product, every step—from hardware installation to software configuration—must be strictly followed in accordance with the instructions; the engineer has detailed the installation and software configuration procedures. Before installation, verify the environment and ensure the board is undamaged; then, proceed with installation. After confirming the system is fully powered down and residual charge has been dissipated, align the board with the chassis slot, slide it in steadily until fully engaged with the connector, and tighten the panel mounting screws. Cross-reference wire numbers and terminal numbers against the original manufacturer's wiring diagram. Strip 6mm of insulation, insert the wire into the terminal, and tighten the screw clockwise; ensure the wire marker sleeve is clearly visible and facing outward, and secure the wire bundle with cable ties. After wiring is complete, use a multimeter in continuity mode to verify signal circuits while the power remains off. Once everything is confirmed correct, proceed to use Trisation 1131 (software specific to the Mark V); the engineer opens Trisation 1131, creates a new project, and selects the Mark V controller. Navigate to I/O Configuration and select "Add Module": DS200PTBAG1B; set the slot to match the physical installation (e.g., Slot 6). Enter the description "Protection Terminal Board - Overspeed / Flame Detection," and finally, configure the board parameters.